- Aligning the Steering Pump Pulley
- Any Good Dealers for Servicing in North Jersey?
- paging c4c5specialist
- heads and cams, how to choose
- Analyzed AutoTap data from my 2002 Z06 [Examples]
- dead '98 C5 MN6 on ebay
- texas emissions
- Ordering PIAA 1100x fog lights.
- buy or make cags eliminater?
- Anybody have something painted on the inside of hood ?
- Drag Radials and output shafts
- Just ordered vortex ram
- Severe Duty Output Shaft and Diff Mounts
- Viper T56's vs Vette T56's
- "Low Washer Fluid" Warning on DIC
- To repair or not
- Any detriment to running 17s in the rear?
- Where can you get this front end?
- Went to the dyno and!!!
- Lower temp thermostat questions...
- Surgeing
- Stock tach scrap?
- Stinger Installed Pics
- Injector Duty Cycle
- 01 vs 02 sway bar links rubbber vs steel
- Fair price for a output shaft install?
- Drag wheels?
- Polished Throttle Body - Problems
- Spray questions?
- Are Chassis Dyno's correct?
- What is it?
- VaraRam bad in Rain... or Just Puddles?
- HRE Valve stems
- Need Help Locating>>>
- Stinger Installed Oh The Beautiful Music
- Vette Doctors or Cartek?
- To Coat or Not to Coat?
- Modifying a stock airbox?
- CAGS disable problem
- Does WOT PE really look at LTFT?
- Front brake hose
- 01 clutch replaced with all 02 parts
- Computer tuning results
- 02 Zo6 Back From Cartek!!
- Lengenfelter SuperCharger reliability
- Did I install my Donaldson A/F right?
- 275/40/17 Supercar tires in front
- In house C5 Computer Programming on Dyno Now Available
- How to get replacement parts?
- Got a "Z06 Funny Noise Question"...
- DFW Chevy Dealers / Service
- Very interesting Vortex vs Vararam test results
- Detailing
- Vortec-MAF tuning
- Need some education
- Break in period
- Going to reverse? What's UP ?????
- First oil change... 500 or wait...
- whats best first mod???
- Why does Chevrolet use different size wheels on the front and rear of the Corvette?
- Trick Octane boost
- Checked 2002 Z06 Fuel Trim Cells
- Another happy Stinger customer.
- Ruined F1SC tires
- Drivers side mirror vibrates
- BPP Shifter Vibration
- Steering wheel replacement
- Made appointment with the Dyno Tuner!
- Need Help with clutch TSB
- Tire Dressing
- Ported TB question....
- T1-Cobra Installed Thanks Halltech Plus kill story
- Service Active Handling -- C1296 H
- Leaky Tranny
- Help - Fuel smell from rear of car
- LS6 Edit in CA. ???
- Glitches reading PCM with LS1Edit
- I need mod help !
- 'X' Pipe Questions
- Corner weighting question.
- Fuel Guage Problems Continue
- Results after PCM programing.........
- Disc Brake Cooling Ducts
- Anone add a Vararam with S2 Heads and Cam?
- Want to see why the crappy H-pipe makes jingle noises?
- NA vs Supercharger
- Kirban replaced my BPP shifter! Good change
- BHPvsRWHP
- Question on Running Accesories
- ODBII Codes
- Will my 01 Z06 headers fit on a 02 Coupe???
- Oil Filter Magnet........
- wheel paint needed for 02
- 2003 torch red z06
- Superchips Program
- HELP with CODE P0442 C from PCM
- zaino??????
- How many switching intakes - to Vararam?
- Seat Height
- Question for C4/C5 Specialist
- where is peak HP and peak TQ on a stock LS6?...what RPM?
- Rear Ends....
- Real GM OEM wheels??
- New Clutch
- hydro lock?
- Hard Starting
- proud new owner
- Zaino queston
- Vibration at 60-70mph
- magnetic oil plug
- Got my Z dyno'd
- LG Motorsports G5 vs. FAStech F1 cam shootout!!
- Additional front brake ducts
- BPP Shifter Received-Installed-Driven
- Just Got Back From Cartek
- MTI and LS1 edit
- M.p.g.
- Quick lowering question
- ? on GM buyback
- 345's on rear?
- Removed Halltech T1 and A/F Calibrator
- TB's
- Estimate my HP...
- The Zaino thing ! Please Read!
- Any interest in a Single Turbo system for the Z06?
- $800 for Reprogram of just MAFT?
- 02 Z06 Torque Management
- Corsa Ti Questions
- Has anyone done a line lock?
- What kind of fire extinguisher???
- Front Brake Duct Extensions?
- Shifter Stuck???
- Zaino....again
- 1st Ever Dyno Need Tips
- Does the Interior hold up?
- The Paddock tutorial on CAGS! needs to be revised.
- Well folks - I may have a new cam on saturday....
- Just picked up my o1 Z06
- Doing the lowering mod right now, need input asap!
- Katech 427 or Lingenfelter TT OPINIONS PLEASE
- 450+RWHP with bolt on mods?
- Mod Red & Black Seat Covers
- 18" Wheels All Around -- Need Some Advice
- anybody's trunk hood leak?
- C6 = Ugly as Shat
- Question for all u maft tuning wizards out there
- Exhaust System Swap
- Vararam intake and rain....is this a no no?
- Mods on the way need dyno help
- At what point do you need bigger injectors??
- Corsa X pipe, with Corsa Ti exhaust.
- Brake pad initial bite question
- Help B2282, B2283, B2284,(LDC and RDC) U1064 (BCM)
- Where oh where is my tach signal?
- Shifter Knob
- Real brushed Aluminium Dash Kits.
- Performance Mods
- X-Pipe Bassani or Corsa
- DIY Wide Band O2
- Stock air box removal
- recall
- Vortex rammer? i am so confused
- 1/2 tank then EMPTY!!
- VaraRam - questions on filter
- Lowering method.
- Tire Life.
- Bye Bye Red
- If you're running ET streets/drags at the track, pls step inside
- GM and tranny - PART 2
- Is donig a LS6 edit on a 'pretty much' stock Z06 going to give any gains?
- Clutch Question
- Lots of questions??????????????
- GM says my rear diff leak is caused by..
- Heading to Cartek Today
- Problems with new Z06
- Z06 information needed
- 3.73 gears. Yeah or nay?
- HRE's & Zaino Equals
- HELP need autotap 1.11 version program
- tire pressures
- FLP Long Tubes Installed - WOW
- supercharger/turbo kits?
- Wrong section but how do i post my timeslip?
- Wrapping Brake Lines
- Duty Cycle
- Cold TStat appearance
- I have an interesting question regarding SAE corrections
- c4c5specialist - need some advice!
- Car pulls to the left and right under hard breaking.
- Balancing Front Wheels
- Water Wetter
- HID lights ?
- How to brackets for PIAA lites.
- Won't Idle!
- 02 Z06 front wheel
- Picked up my Z at Lingenfelter
- Rear louver question
- Modified Audio Systems.
- What Oil Do You Use For Your Z??
- Borla XR-1 Sound clips
- Any alternative coolant mixes?
- Help Please, DIY-AC Delete Instructions.
- Best Valve Stems for Chromies??
- GM says they will NOT honor my powertrain warranty (story)
- GM "Master Mechanic" is that good ?
- Ceramic BreakPad is harmfull for your Z???
- Ordered 180* Thermostat....
- Wide!!
- Aftermarket Rims and Tires
- Mounting chromies..
- Nose protection
- 30lb inj, cold air boxes, maft versus stock-I need ur help!,
- Which X Pipe Would You Choose?
- if (Pedal.Spongy == Pad.Taper) then Pad.Flip
- Intake Air Temp. Not my Friend?
- Exhaust Jingle..........
- Just installed the Ripper shifter....
- Power Programming
- underdrive pulley for power steering?
- how hot should the rear differential fluid be?
- tranny temperature readout?
- How to choose the right thermostat?
- Ceramic brake pads...
- Z06 Wheel Touch up?
- why am I losing 10hp/10tq between dyno runs??
- Paging ZDOG
- Trunk lid cover (inside)
- Ouch! Just lost third gear.
- Sticking clutch in a 2002 C5
- How Loud?
- Bottle mounting pics
- Borla Stingers Make Sweet Music!!!
- Anyone ever get behind the wheel of anything faster than the Z?
- Calling All Bone Stock 01 Owners -please Post Your Dyno Result
- Check Engine Light
- Is there a "best"brake pad ?
- Signature needed??
- X or H Your Opinions Wanted
- dyno in N.C.??
- I'm seriously considering getting and ATI installed..Any words of wisdom ??
- Fan relays?
- Shop (upgrade) West of Chicago
- My newest Modification for the Z
- Got the Belangers and the Corsa Z on finally
- Updated - Higher Flowing Filter For Vortex
- Loudness of FLPs
- Another satisfied Stinger owner
- heads and cam guy....did you get difrent fuel rail covers?
- Best Shift point for 1/8 racing
- Suspension Bushing Lubricant