You should check this out.....

[BAD 06]

I found something pretty scary. I just got my car back from installing the Vararam, Corsa Ti mufflers (ahhhh) and an alignment. While on the rack, the tech noticed that one of my motor mount nuts was missing and the other had two threads left until it fell off. I think this might be worth checking on your cars.

Also, can someone tell me the torque spec on the nuts? We put them to 50 lb-ft.

Thanks,

Chad

[mgarfias]

I'll look em up this evening if no one else has gotten to it before me.

[fcalmes]

Thanks for sharing, Chad!! That's great information!! Hope it helps the members!!

[No Doubt]

Service manual Vol 2, Pg 6-40 says: Tighten the engine mount bracket bolts to 37 lb ft.(bracket that bolts to the block) and page 6-41 says Tighten the engine mount-to-engine mount bracket nut to 48 lb ft. (The round rubber? engine mount itself with a single bolt/nut through the center)

[70boss302]

Thanks for the "heads up" warning. I will check mine this weekend! Bill

[BAD 06]

Thanks NoDoubt, looks like we had a real good guess on torque.

Chad