2004 Wiring Help

[TheAngryTiTTy]

Okay, Im hardwiring my V1 into my 2004 and Im just wondering what everyone uses as a ground (damm you pre 2004s are lucky with the accessory harness)... Im getting power through a Mini Add-A-Circuit holder, and I just need to ground the V1... I took a quick look at the area where the fuses are and didn't see much, which is why I posted..


Thanks folks

_John

[wlxx861]

Any bolt or screw will do, just scrap away a little bit of paint. Check it with an Ohm meter first.

[TheAngryTiTTy]

Anything specific? I was checking around the are where the BCM sitting but I didn't see any bolts.. I really don't want to start yanking panels off my 1 week old car trying to hunt down a bolt... Just looking for an exact location of a bolt or something..

Thanks..

[reproman]

Lay on your back on the driver's side. Look right above the gas pedal, and you will see a retangular metal box that uses two or more screws to hold it in place. Just take the one closest to the driver (lots of room to get your fingers and a socket wrench up there), and connect there!

[TheAngryTiTTy]

Thanks guys, Ill remember this for next time.. I ended up pulling up the door sills and finding some bolts behind the panel on the passenger side.. It all worked out, the radar is up and running, nice to be done with that damm cable..