Z06Vette.com Z06Vette.com

Go Back   Z06Vette.com - Corvette Z06 Forum > C5 Z06 Specific Topics > C5 Z06 - Pit Road
Register Home Forums Gallery Active Topics Search Today's Posts Mark Forums Read Casino

       
Z06Vette.com is the premier Corvette Z06 forum on the internet. Registered Users do not see the above ads. Please Register - It's Free!


Closed Thread
 
LinkBack Thread Tools Display Modes
Old 02-15-2005, 02:08 PM   #1 (permalink)
Supporting Vendor
 
DJWorm's Avatar
 
Join Date: Apr 2001
Location: Erie, Pa.
Posts: 5,352
Send a message via AIM to DJWorm
Engine Torque Specs

ALL TORQUE SPECS IN #-Ft. UNLESS OTHERWISE NOTED.
NOTE: ALL Blind Holes MUST be cleaned and blown out before assembly. Torque-To-Yield Bolts MUST NOT be reused.

APPLICATION: / TORQUE SPEC:

AC Compressor Bolts / 37
AC Compressor Bracket Bolts / 37
AC Idler Pulley Bolts / 37
AC Tensioner Bolt / 18
AIR Pipe to Exhaust Manifold / 15
Camshaft Retainer Bolts / 18
Camshaft Sensor Bolt / 18
Camshaft Sprocket Bolts / 26
Catalytic Converter Nut / 18
Clutch Pressure Plate Bolts (3 passes in Seq.) = 20/40/52
Sequence: 1-4-6-2-3-5
Con Rod (1st pass) / 15
Con Rod (final pass) / + 60 degrees
Crankshaft Balancer (1st pass using old bolt) / 240
Crankshaft Balancer (2nd pass use NEW bolt) / 37
Crankshaft Balancer (final pass) / + 140 degrees
Crankshaft Oil Deflector (Windage Tray) Nuts / 18
Cranshaft Position Sensor Bolt / 18
Crankshaft Bearing Cap Bolts (Inner 1-10)
(1st pass in Seq.) = 15
Crankshaft Bearing Cap Bolts (Inner 1-10)
(final pass in Seq.) = + 80 degrees
Crankshaft Bearing Cap Studs (Outer 11-20)
(1st pass in Seq.) = 15
Crankshaft Bearing Cap Studs (Outer 11-20)
(final pass in Seq.) = + 53 degrees
Crankshaft bearing Side Bolts (21-30 in Seq.) = 15
Crankshaft Bearing Cap Sequence: (use oil and hand tighten first)
29-25-21-23-27 SIDE
19-15-11-13-17 OUTER
09-05-01-03-07 INNER
FRONT
10-06-02-04-08 INNER
20-16-12-14-18 OUTER
30-26-22-24-28 SIDE
Cylinder Head Bolts (All M11)
(1st pass in Seq.) = 22
Cylinder Head Bolts (All M11)
(2nd pass in Seq.) = 90 degrees
Cylinder Head Bolts (All M11 EXLUDING Med. Length F/R Bolts)
(final pass in Seq.) = 90 degrees
Cylinder Head Bolts (M11 F/R Med. length)
(final pass in Seq.) = 50 degrees
Cylinder Head Bolts (M8 Inner in Seq.) = 22
Cylinder Head Bolt Sequence:
15-13-11-12-14 Top/Intake
10-03-01-05-09
07-06-02-04-08 Bottom/Exhaust
Cylinder Head Coolant Plug / 15
Cylinder Head Core Hole Plug / 15
Drive Belt Idler Pulley Bolt / 37
Drive Belt Tensioner Bolts / 37
Engine Block Coolant Drain Plugs / 44
Engine Block Heater / 30
Engine Block Oil Gallery Plugs / 44
Engine Crossmember Bolts Large / 107
Engine Crossmember Bolts Small / 92
Engine Front Cover Bolts / 18
Engine Mount Heat Shield / 89 INCH #'s
Engine Mount STUD to Engine Block / 37
Engine Mount Through Bolts / 70
Engine Mount Through Bolt NUTS / 59
Engine Mount to Engine Block BOLTS / 37
Engine Rear Cover Bolts / 18
Engine Lift Bracket M10 Bolts / 37
Engine Lift Bracket M8 Bolts / 18
Engine Valley Cover Bolts / 18
EGR Valve Bolts (1st pass) / 89 INCH #'s
EGR Valve Bolts (final pass) / 22 FOOT #'s
EGR Valve Pipe to Cylinder head Bolts / 37
EGR Valve Pipe to Exhaust manifold Bolt / 22
EGR Valve Pipe to Intake Manifold Bolts / 89 INCH #'s
Exhaust Manifold Bolts (first pass in Seq.) / 11
Exhaust Manifold Bolts (final pass in Seq.) / 18
Sequence: 6-3-1-2-4-5
Exhaust Pipe Manifold Nuts / 26
Fuel Injector Fuel Rail Bolts / 89 INCH #'s
Flywheel Bolts (3 passes in Seq.) / 15/37/74
Sequence: 1-4-6-2-3-5
Flywheel to Auto Torque Converter Bolt / 44
Generator Bracket Bolts / 37
Generator Rear Bracket to Engine Block Bolt / 18
Generator Rear Bracket to Generator Bolt / 18
Ground Strap to Cylinder Head Bolt / 37
Ignition Coil Bolts / 106 INCH #'s
Ignition Coil Wire Harness Connector Bolts / 106 INCH #'s
Intake Manifold Bolts (1st pass in Seq.) / 44
Intake manifold Bolts (final pass in Seq.) / 89 INCH #'s
Sequence:
Knock Sensor / 15
Oil Filter / 22
Oil Filter Fitting / 40
Oil Level Indicator Tube (Dipstick) Bolt / 18
Oil Level Sensor / 115 INCH #'s
Oil Pan Baffle Bolts / 106 INCH #'s
Oil Pan Close-out Bolt LT & RT Side / 106 INCH #'s
Oil Pan Drain Plug / 18
Oil Pan M8 Bolts (pan to block & pan to front cover) / 18
Oil Pan M6 Bolts (pan to rear cover) / 106 INCH #'s
Oil Pressure Sensor / 15
Oil Pump to Engine Block Bolts / 18
Oil Pump Cover Bolts / 106 INCH #'s
Oil Pump Relief Valve Plug / 106 INCH #'s
Oil Pump Screen Nuts / 18
Oil Pump Scren to Oil Pump Bolt / 106 INCH #'s
Oil Transfer Cover Bolts / 106 INCH #'s
02 Sensor / 31
PCV System Strap (Rt Ft vapor vent pipe stud)/106 INCH #'s
Power Steering Pump Bolts / 18
Power Steering Pump Brace Bolts / 18
Power Steering Pump Bracket Bolts / 37
Spark Plugs (NEW) / 15
Spark Plugs (used) / 11
Starter Motor Bolts / 37
Throttle Body Bolts / 106 INCH #'s
Transmission Bell Housing Bolts / 35
Valve Lifter Guide Bolts / 106
Valve Rocker Arm Bolts / 22
Valve Cover Bolts / 106 INCH #'s
Vapor Vent Pipe Bolts / 106 INCH #'s
Water Inlet Housing Bolts / 11
Water Pump Bolts (1st pass) 11
Water Pump Bolts (final pass) / 22
Water Pump Cover Bolts / 11
Water Pump Pulley Bolts (1st pass) / 89 INCH #'s
Water Pump Pulley Bolts (final pass) / 18

This data is presented for convienience only. Information sources are Courtesy of Helms Manuals, Mallett Cars, Ltd., "Chevy LS1/LS6 Performance" by Chris Endres & HP Books, "Chevy LS1/LS6 V8s" by Will Handzel and CarTech, Chevrolet Owners & Operators Manuals and my own data. You should consult these sources to confirm the accuracy of the data. I highly recommend the purchase and reading of these books and manuals.
__________________
Williams GT Engineering @ www.WilliamsGTEng.us
F1 Technology, Parts and Preparation for Competition Corvettes
AMSOIL Online Store

Last edited by DJWorm : 02-20-2006 at 06:07 PM.
DJWorm is offline  
Sponsored Links
Advertisement
 
Closed Thread


  Z06Vette.com - Corvette Z06 Forum > C5 Z06 Specific Topics > C5 Z06 - Pit Road



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
I need engine torque specs..... PerforminNorman C5 Z06 - Pit Road 10 10-10-2005 08:39 AM
Tranny/Diff/Cooling Specs & Capacities + Torque Specs DJWorm C5 Z06 - Pit Road 0 02-15-2005 11:52 AM
Torque specs? quicksilvr C5 Z06 - Pit Road 3 09-19-2004 04:05 PM
Need some torque specs. jknight C5 Z06 - Pit Road 2 07-22-2002 07:42 AM
What is the Torque specs? 01BlackZ06 C5 Z06 - Pit Road 4 03-23-2001 10:02 PM

Links

» Log in
User Name:

Password:

Not a member yet?
Register Now!
» Wheel & Tire Center


» Search Used Cars
Search for used vehicles by ZIP, please enter Zipcode below:
Sponsors

Powered by vBadvanced CMPS v3.0 RC1

All times are GMT -7. The time now is 01:04 AM.

Powered by vBulletin® Version 3.6.7
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.1.0
  • AutoForums.com
  • Truck
  • European
  • Import
  • Domestic
  • Manufacturer

AutoForums.com is the premier network of enthusiast-owned enthusiast-operated automotive communities.
We operate more than 100 automotive forums where our users consult peers for shopping information and advice, and share experiences and opinions as a community.

Visit AutoForums.com today.

For advertising information, please visit our AutoForums.com website and Contact Us, or send an email message to sales@autoforums.com.