Z06Vette.com - Corvette Z06 Forum

Synergy Motorsp · 03-11-2006, 08:34 PM

Here are the resaults from our Stage one baby camshaft with Kooks long tube headers and tuning. The results where awsome for what is done to the car. I must say the computer and the tuning is very interesting on these new 32 bit platforms. They do alot of adjusting constantly. But once they get dialed in, they become very consistant. So for a camshaft not too far off from stock, and headers, this car moves pretty good. Cant wait till our stage two cam goes in.

Enjoy.

The smaller numbers represent everything with the filter in. And the other graph represents when I took the filter out. You can tell these cars need a good filter in them.

Rick

Larger graph

JBP8653 · 03-11-2006, 08:43 PM

specs on the cam?

**FRC Tom** · 03-12-2006, 04:33 AM

Not used to reading these dyno sheets, was that a 3rd gear pull Rick?
I see 115 mph.

Richard Branca · 03-12-2006, 01:15 PM

rwhp & rwtq #s?

benenati379 · 03-12-2006, 01:40 PM

Am I reading this right? 535hp from a cam only?

Is this a C6 Z06? It is in the C5 section.

DDNZ06 · 03-12-2006, 06:52 PM

Details Please!!!

Synergy Motorsp · 03-15-2006, 12:30 AM

Yes, its rear wheel numbers. Cam and long tube only, after tuning of course.

4th gear is the one to one gear, and thats all that I can use.

Its here because it seems my posts keep getting thrown around everywhere.

Rick

Pakisho · 03-15-2006, 04:08 PM

Redline at 111 in 4th?

And the ratio says 3.80......did the guy change the gears?

Synergy Motorsp · 03-15-2006, 04:11 PM

Quote:

Originally Posted by Pakisho

Redline at 111 in 4th?

And the ratio says 3.80......did the guy change the gears?

No, I just dont put the tire size in the dyno, so that wont read right. It gives me the option to do it though.

Rick