Z06Vette.com - Corvette Z06 Forum - View Single Post - throttle body by wire
View Single Post
post #5 of (permalink) Old 08-08-2019, 10:11 PM
Alain Serhal
Junior Member
 
Alain Serhal's Avatar
 
Join Date: Aug 2019
Location: Lebanon
Posts: 17
Don't forget the learning procedure for the idle rpm while changing TB and of course you should adjust the position pedal sensor of the throttle body to be zero for not making the car stalling or higher rpm at idle. N.B. don't play with the butterfly blade or if you want to remove carbon from the old one just with your finger smoothly clean them without spraying too much TB spray cleanser left & right edges pay attention also on the smallest tiny sensors inside the TB tube.
I think he is right about the LS2 or LS7 243 casting wide TB drived by electric wire they would match 90-92mm if you couldn't find anything else for your engine support.
Alain Serhal is offline  
 
 
For the best viewing experience please update your browser to Google Chrome