Corvette Z06 Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
220 Posts
Discussion Starter · #1 ·
I just got a 99 Coupe with auto and performance axle. I was wondering what it should ET and dyno. It is 100% stock with 32k miles. Thanks for any info :)
 

·
Premium Member
Joined
·
20,625 Posts
With a Corsa catback exhaust only and a standard axle ratio (2.73) my 99A4 coupe turned a [email protected] at Etown.
A 3.15 should knock about .5 off of that figure.
 

·
Registered
Joined
·
220 Posts
Discussion Starter · #3 ·
Thanks. Mine feels strong, nowhere as good as my 01 Z06 did :D . I had a 2002 WS6 6 speed with long tubes and some other minor mods and was wondering if my Vette could run with it.
 

·
Registered
Joined
·
413 Posts
probably mid 13s...rwhp around 285 to 290...just a few mods will up her to about 320rwhp and high 12s in 1/4....good luck.
 

·
Registered
Joined
·
17,744 Posts
gtx76 said:
I just got a 99 Coupe with auto and performance axle. I was wondering what it should ET and dyno. It is 100% stock with 32k miles. Thanks for any info :)
It should Dyno around 290 RWHP :coo:

.
 

·
Premium Member
Joined
·
20,625 Posts
After the exhaust, I had a Vortex air box put on and did a Steve Cole Power Loader download. Ran consistent [email protected] Never could break into the 12's, until I bought my 01Z06.
 

·
Registered
Joined
·
220 Posts
Discussion Starter · #7 ·
Any ideas as to what the most "bang for the buck" mods would be? This is a daily driver so I have to take that into consideration.
 
1 - 8 of 8 Posts
Top