Corvette Z06 Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
Went to the dyno today...just wondering how these numbers sound...

I installed borla stingers and the k&n intake system....

358.7 rwhp 344.4 ft/lbs torque

are these numbers good, bad...?
 

·
Registered
Joined
·
7,548 Posts
Those are nice numbers for any Z with those mods...especially an 01. :cheers:
 

·
Premium Member
Joined
·
5,276 Posts
Those seem like uncorrected numbers - 358rwhp for a 2001 just from stingers and intake SAE corrected seems a little too strong.

I would have expected 335ish rwhp before and after the Stinger/K&N install.
 

·
Registered
Joined
·
53 Posts
Discussion Starter · #5 ·
hmmmm

hmmmm, ill post the dyno chart when i get hands on a scanner, but its true, those r the number....
 

·
Registered
Joined
·
1,957 Posts
01Z_06 said:
Went to the dyno today...just wondering how these numbers sound...

I installed borla stingers and the k&n intake system....

358.7 rwhp 344.4 ft/lbs torque

are these numbers good, bad...?

Well Hope I am not missing the mark here but it strikes me as pretty typical for an 02-04 Z06, meaning you have have made
up the 20 HP all right
 

·
Premium Member
Joined
·
5,276 Posts
01Z_06 said:
hmmmm, ill post the dyno chart when i get hands on a scanner, but its true, those r the number....
Well - considering dyno's are seldom good for absolute comparisons but rather establishing a baseline and then a delta after mods are made - perhaps that dyno is very optomistic, that is the strongest 2001 Z06 bar none - or it is not as stock as you think ;)

maineyak_2000 said:
Well Hope I am not missing the mark here but it strikes me as pretty typical for an 02-04 Z06, meaning you have have made
up the 20 HP all right
However, those mods would not equate to 20hp, but a very good tune of the car could possibly net such results. Possibly -in an exceptional case. :)
 
1 - 9 of 9 Posts
Top