Corvette Z06 Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
137 Posts
Discussion Starter #1
Does the rubber molding that runs along the A-pillar get tucked in the plastic cover or stay outside the plastic cover..
You'll see what I mean when you open the door 0n your Z06..
Please advise??
 

·
Registered
Joined
·
1,265 Posts
I was going to say it goes under, but then I looked and one side is out and the other side is in.. go figure....
Ernie
 

·
Premium Member
Joined
·
7,247 Posts
OUT

Mine came out. When the dealer replaced my defective headliner, he couldn't remember how they were. I knew they came "out" but we went and looked at a used Z06 on the lot anyway and they were out also.

FiveOJoe
 

·
Registered
Joined
·
928 Posts
Sounds like we need a poll here: Do you have an inee or an outee? Sheeze getting near the bottom of the barrel just to buid up posts.
Stan
 

·
Registered
Joined
·
1,238 Posts
Snap it off and tuck it if you like. My A pillar now has 3 outee's! Air/Fuel Ratio, Boost and Pressure. You are gonna love the pics of 3 gages to the left.

Jeff Nation
 
1 - 7 of 7 Posts
Top