[03YellowZO6]

i been told that you could put a 16 inch rim on the back of a ZO6 with a full slick. anyone here have this or know of it being done?

 

[KCMAGS]

16" M/T streets are popular on vettes & produce nice results.

 

[BluMachine]

I use an old ugly set of 16" x 8" 5-spoke F-bod rims that I used on my SS. You have to do some grinding around the upper ball joint to get them to fit. It sounds worse than it is. I used a file and only took off the bare minimum to get clearance. Took a couple of hours for each side. This was done over a year ago and have gone nearly 20K miles, have done a track day at Sebring and several Autox events with no problems.

I have a set of the new MT ET Street Radials 255-50-16 and while it looks like hell, I can out 60' guys on 305-45-18 Nittos all day cause the 16s have alot more sidewall. I consistently pull low 1.7s with a quick slip off the line. I drive it back and forth to the track 20 miles one way at highway speeds with no problems :jammin:

 

[MikesZ06]

i been told that you could put a 16 inch rim on the back of a ZO6 with a full slick. anyone here have this or know of it being done?

It might look something like this....

Mike

 

[03YellowZO6]

It might look something like this....

Mike

what type of rims are they on the car in the pic?

 

[REDGAR]

****edited****

 

[coopz06]

I would buy a set of Weld Pro Stars with ET steets. They are 16 inch and require no grinding.

CoopZ06

 

[Kat]

It might look something like this....

Mike

I agree with Mike. I like his with the black centers better then mine p:

 

[REDGAR]

I would buy a set of Weld Pro Stars with ET steets. They are 16 inch and require no grinding.

CoopZ06

From what I understand Weld does not make a proper wheel (offset) for our C5.

If you have different info from Pro Star, please advise.

 

[THRLSKR]

You may want to try Bogart...they have the correct offsets for the C5, and are lighter than CCWs.

Bill