Corvette Z06 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
281 Posts
Discussion Starter · #1 ·
Whilst in Germany a couple of weeks ago I kept having problems with the clutch pedal going "soft".
Long story short, the heat from the turbos was causing the clutch master cylinder fluid to boil and eventually it also caused the failure of the connector between the Master Cylinder and the Actuator.
I have a new Master Cylinder on order but the Z06 Service Manual Page 7-347 (I think) mentions a GM special tool J36221 is required to separate the connectors and it is also used for re-connecting.

Anyone got any ideas where I get one of these J36221 tools from?
 
1 - 3 of 3 Posts
Top