Corvette Z06 Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
155 Posts
Discussion Starter · #1 ·
I have seen some that look to small on a Z06 with the stock exhaust. Which do you guys recommend?

Jackhammer:z:
 

·
Premium Member
Joined
·
12,352 Posts
I bought the rolled stainless stell exhaust plate, check our vendors, very happy with it and its fit. Bottom lip rolls under for a nice finished look.



Mark
 
G

·
I like that one the best as well..

I think the rolled edges are important and although I have the one with Corvette insignia(glued on to a flat plate)..I have tired of all the flags on my car..

Hindsights 20/20..I would go with a more sublte type next time around as photographed above..
 

·
Registered
Joined
·
3,213 Posts
mdickie said:
I bought the rolled stainless stell exhaust plate, check our vendors, very happy with it and its fit. Bottom lip rolls under for a nice finished look.



Mark
We carry the version above. Very nice quality for 90 bucks, shipped.

RG
 

·
Registered
Joined
·
1,238 Posts
fcalmes said:
FUBU has one of the rolled plates on his Z and it is the nicest one I've seen!!
I like his also----my only gripe--those suckers are hard to shine! It's really low and tucked back there quite far!

Hint: Wait for exhaust to COOL DOWN before polishing the exhaust plate. :eek:
 

·
Registered
Joined
·
1,103 Posts
Exhaust plate...........

I bought the Carbon Fiber one and has the 2002 Z06 fender badge adhered to it..Looks really stealthy. Believe I purchased it from Corvettes of Houston? Not really sure,but could always dig up my receipts and tell you if interested....
Zman
 
1 - 10 of 10 Posts
Top