Corvette Z06 Forum banner
1 - 3 of 3 Posts

76 Posts
Discussion Starter · #1 ·
Finish Line Performace is TOP NOTCH Company!!! My 2 day experience at Dan Bills shop was the best finishing touches to my now changed Z06. I am now ready for a new season in SCCA SOLO II.
Winter & Spring upgrades>
1.LGM long tubes with random cats
2.Hotchkiss sway bars
3.Hardened axle shaft
4.DTE strut brace
5.Aluminum frame stiffener & heat shield
6.RD Racing frame support( 4 point roll bar)
7.Frozen rotors
8.Stainless steel caliper pistons(front)
9.KFP Gold racing pads
10.LS 1 Edit
11.Katech throttle body(polished & CC'D)
12.Vararam B2
13.MSD wires
14.NGK plugs
15.CCW polished race wheels with Hoosiers
16.Drain & tech2 brake fluid-Motul 600 again
17.DRM brake ducts
18.LGM rotor ducts
19.2003 Chevy extended cab Z71
20.Trailer World aluminum open trailer
I gained 40 RWHP & 40 ft lbs torque. My Z06 now roars when the pedal hits the floor & quiet when its not!! This is what I wanted. I have the stock mufflers.
My Z06 now has the power for SPEED & STOPPING!!!!!!!!
I want to thank my FRIEND Gary for doing the brake work!
I also thank an long time FRIEND Mike Ohrt at Mikes Body Shop for the GREAT Job installing the roll bar!
The racing seat & harness will be installed after I return from a 2 week trip to the West Coast with 14 other Corvettes in June.
Last I say how lucky I was to have Finish Line Performance be the closest shop for the LS1 Edit, dyno tune, axle & strut brace install!
April 24th is my first race. There is only 2 things left to do> Wash My Z & put the CCW/Hoosiers on. I never thought this project would be so stressful & take so long. Good things happen when alot of patience & hard work are applied.
Carroll Lawton
Long Grove.IA.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.