Corvette Z06 Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #4 ·
Yes I do have the charts but after I scanned it, it came out way too big! I'll have to work on getting it smaller.
Frank, the last two dyno runs did go to approx. 5800 rpm. The dyno operator had me quit since the power was going down after the mid 4000's. I also had "service active handling" and "service ABS" codes, if that means anything. The car runs great with good 1/4 mile times (12.83 @ 112.5), burns no oil, and gets 26 Miles per gallon on our California crap gas! Any other ideas on these dyno numbers?
Bob
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top