Corvette Z06 Forum banner

Jet performance chips???

Jump to Latest Follow
1 - 2 of 2 Posts
I

·
Registered
Joined
·
166 Posts
Discussion Starter · #1 ·
I will finally get my Z06 on Thursday of this week. I'm purchasing a 2001 with less than 2,500 miles on it. The person I am buying the car from installed two aftermarket mods. The first mod is the Halltech TRIC intake. I've read extensive threads on the TRIC, seems like a good mod. The other mod is called a jet chip. I went to their website to find out what I could about this mod. First, I didn't find any "chip" on their site that was Z06 specific. Second, I've never heard anyone on this board discuss this chip.

So, any comments on the Jet Chip? I would really appreciate feedback.

Thanks
 
Save Share
Reply
I

·
Registered
Joined
·
4,332 Posts
#2 ·
itry2hide


Best of luck with your new Z. Lots of mods been done on this forum, I know the halltech is good. The chip im sure has been done and somebody will jump in. I know they are a reputable concern..........


:)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Recommended Reading
Read More
  1. C5 Z06 - Pit Road
    Im about to install my third set of rings in this build. The engine is a stout 441 cube LSX 454 block. 4" stroke GM LS7 Crank, 4.185" bore. Eagle 6.125" Rods. Street raced occasionally in Mexico. Driven almost daily prob 200 to 300 miles a week. Using 1QT or more a week. It almost uses as...
  2. C5 Z06 - Pit Road
    Gonna be buying a Z06 real soon and wondering how much HP the stock rods/pistons (bottom end etc.) can take as far as power production. I'm gonna porbably do Ported heads/Mti cams/full exhaust and some other junk but need a good base on how far is too far for the stock motor? I tried to a do...
  3. C5 Z06 - Pit Road
    Been thinking about a few additional modifications to my car. I currently have a 2002 Lingenfelter C5 Z06 with the Magnuson supercharger package, cold air intake, and B&B exhaust. I believe the car dyno'ed at 492 rwhp pushing 6 psi of boost from Lingenfelter. I have been debating lately on the...
  5. C5 Z06 - Pit Road
    Hey all- In the middle of my intercooled magnacharger install (just finished putting the front end back together after drilling into the harmonizer, etc) and am starting to replace the fuel pump.... heres the problem - need to have the tank at 1/8th or less and I am nearly full. I cannot get...
  6. C5 Z06 - Pit Road
    Hello ! I just bought a 04 z06 with a brand new built ls3 and 6 speed transmission and rear end. After driving it for a bit I noticed a sort of faint spinning grinding noise which seems to be coming somewhere under the shifter . It’s there when idling and when foot is on the clutch . It’s not...
Read More
About this Discussion
1 Reply
2 Participants
Last post:
IMA Z06
Corvette Z06 Forum
We’re a forum community dedicated to the Chevy Z06 Corvette. Come check out discussions on performance, specifications, modifications, purchasing, maintenance and more!
Full Forum Listing
Explore Our Forums
C5 Z06 - Grandstand C5 Z06 - Pit Road Member Sales/Trades - Parts & Cars C6 Z06 - Pit Road C6 Z06 - Grandstand
Recommended Communities
Community avatar for Chevrolet Corvette Forums
Chevrolet Corvette Forums
126K+ members
Community avatar for Snowmobile World
Snowmobile World
214K+ members
Community avatar for Harley Davidson Pan America Forum
Harley Davidson Pan America Forum
NEW!
190+ members
Top