[1baduramax]

I made some new emblems at work and today I removed the old ones and put on these that are a little darker. Did front and rear, I also got the car lowered!
http://i21.photobucket.com/albums/b283/1BADURAMAX/Newemblem.jpg
http://i21.photobucket.com/albums/b283/1BADURAMAX/Newemblem2.jpg
http://i21.photobucket.com/albums/b283/1BADURAMAX/Picture3840599.jpg

Now if it wasnt 38 degree's I would wash it!

 

[PerforminNorman]

Lookin good. 38 degrees is a heat wave compared to what we're getting here. Our daytime high is going to be near 15.

 

[wneal]

Looks Great

 

[GTB/ZR-1]

Cool--kinda like a black-n-white pic :thumb:

 

[DennyM]

looks :coo:
How much did you lower it? max on stock bolts or ??
you going to put the stock alignment back on it after it settles or ?
:ity:

 

[1baduramax]

I bought lowering bolts from corvette garage and then we just went low but not too low. I got it all aligned after we did it.

 

[K M]

Looks nice. A black C6 z06 is always good looking.

 

[marcs07z06]

I made some new emblems at work and today I removed the old ones and put on these that are a little darker. Did front and rear, I also got the car lowered!
http://i21.photobucket.com/albums/b283/1BADURAMAX/Newemblem.jpg
http://i21.photobucket.com/albums/b283/1BADURAMAX/Newemblem2.jpg
http://i21.photobucket.com/albums/b283/1BADURAMAX/Picture3840599.jpg

Now if it wasnt 38 degree's I would wash it!

Nice Z06. How did you make your emblems? Very impressive.

Marc
Irvine,CA.

 

[JRTX]

I bought lowering bolts from corvette garage and then we just went low but not too low. I got it all aligned after we did it.

Can you explain the lowering bolts? How much can you lower F & R, and how does it affect ride quality?

 

[1baduramax]

I bought the lowering bolts fom corvettegarage .com dont want to get in trouble for supporting a non vendor so you might find them other places. That was about as low as you could go and the ride is just fine. I own a business that makes decals so I made my own emblems and put a dome or jel-coat over them. I think they look really good and blend with the car well.

 

[GTB/ZR-1]

Can you explain the lowering bolts? How much can you lower F & R, and how does it affect ride quality?

You can also lower enough on the stock bolts to get you where you want--too low & you're doing more harm than good (bad geometry, not enough travel, bottoming out etc).

Ride quality degrades a bit, as you'd be loosing travel & some compliance...

Welcome :thumb:

 

[ZO6 AL-X]

I like the new emblems. The drop looks sweet, too. :thumb: