Corvette Z06 Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
So I was putting a delay bypass in and once installed no pedal response... So I hooked back up with bypass but still no pedal response... It says reduced power now.. I had to remove pedal to access clip to get connection off but I can't figure out what went wrong... I'm freaking
 

· Z06 Tech Advisor
Joined
·
1,947 Posts
Being Corvette has drive by wire
The controllers have multi safety checks to assure nothing goes wrong and causes DBW controller to get out of hand
so slight issues will cause the PCM to go into a limp mode if errors tip

You might luck out by taking the ground cable off the battery for about 5 minutes which will flush out all error codes and cause controllers to do relearns causing the problem to go away
 

· Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Being Corvette has drive by wire
The controllers have multi safety checks to assure nothing goes wrong and causes DBW controller to get out of hand
so slight issues will cause the PCM to go into a limp mode if errors tip

You might luck out by taking the ground cable off the battery for about 5 minutes which will flush out all error codes and cause controllers to do relearns causing the problem to go away
I'll try that.. Let's hope cause I'm freaking
 
1 - 3 of 3 Posts
Top