[proexpert]

Cut 2/3, I think you will like it there and not have to back in.
I removed mine altogether. See these pix:
http://www.cadquest.com/images/lower_front.jpg
http://www.cadquest.com/images/lower_back.jpg
http://www.cadquest.com/images/lower_bushings.jpg

The bushing pic shows the pogo stick for the front (on the left) and the remainder of the rear bushings (the parts I removed, on the right)

Hope this helps, good luck, see you in Carlisle.

 

[proexpert]

My air dam in the front is 1.5" from the road. Okay I'm acting like my 16 year old son, so what? I just think it looks so cool this way, I don't care about the occasional scrape (it's on a hinge) and the ride is fine. Okay it's a bit harsher, harder, rougher, but I still like it, especially on on/off ramps and the faithful empty parking lot. The increase in cornering is cool. I did have it aligned ($95) at all four corners, that is my only cost into the lowering mod.