Corvette Z06 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,319 Posts
A 300M main shaft wouldn't be out of order. But this means the tranny has to come out. Launching hard on ET Streets is actually easier on the drivetrain than launching hard on drag radials. ET Street walls wrinkle while drag radials won't. The wrinkle eases the "shock to the system" a bit. I used to launch at redline on ET Streets without breaking much. Then again, I was only at 385 rwhp.

You won't need a roll cage unless you're dipping into 9s. You will need a roll bar if you run better than 11.50 which, judging from your mods, you most likely will. If you can't hit 11.50s with 433 rwhp, then you suck and you should immediately turn your car over to me :lol: :lol: :lol: Just kidding, bro. Let me know when you plan on heading down to e-town. I'm there at least twice a week.

Paul
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top