Corvette Z06 Forum banner
1 - 1 of 1 Posts

· Registered
98 Posts
Discussion Starter · #1 ·

I am in the processes of lowering my Z. I got the back completed. Did the turn until 2 threads are showing(no bushing cutting). Now I am working on the front. How do you know when to stop turning the bolt to make it low enough?? I am turning it and sometimes it seems the entire bolt is turning and the bushing at the bottom is just turning ??!!

01 Blk/Blk Z06
All options. Soon Ripper. Trying to lower
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.