Corvette Z06 Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
345 Posts
I was told the BSMs are placed on the vehicle using an alignment jig at the factory and they use 3M doublesided tape. They will come off but if your Vette has seen much service in the sun you are possibly going to see a slight paint color difference so make up your mind quickly.

I would also consider just pulling them off with your fingers since files, rasps, and grinding discs can sometimes slip and leave a mark. Hope this helps.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top